With the Ethernet Surge Protector from Ubiquiti you now have ESD Protection for your Outdoor High-Speed Networks! 

Introducing the Ethernet Surge Protector, model UB-ETH-SP, from Ubiquiti Networks. The Ubiquiti Ethernet Surge Protector is engineered to protect any Power‑over‑Ethernet (PoE) or non‑PoE device with connection speeds of up to 1 Gbps.

But what sets the Ubiquiti Ethernet Surge Protector apart from other surge protectors?

• Ideal for WISP Networks

All Ubiquiti airMAX devices are equipped with ESD protection. However, to protect outdoor devices, and to meet certain local code requirements, installing the Ubiquiti Ethernet Surge Protector is essential.

• ESD Protection for Outdoor PoE Devices

Damaging electrostatic discharge attacks and surges are diverted to the Ubiquiti Ethernet Surge Protector and safely discharged into the ground, so network devices are protected.

• Low-cost Protection

The Ubiquiti Ethernet Surge Protector is a cost-effective solution for protecting outdoor Ethernet devices from damaging electrostatic discharge and surges. Since all Ubiquiti® airMAX® devices already have robust ESD protection built in, adding the Ubiquiti Ethernet Surge Protector to the installation provides an additional layer of protection to the network.

• Fast Installation

The Ubiquiti Ethernet Surge Protector was designed for easy, plug and play installation:

1. Attach the Ubiquiti Ethernet Surge Protector to a grounded pole.
2. Drill a pilot hole into the pole.
3. Fasten the ground screw.
4. Connect the Ethernet cables.

• Maximum Compatibility

Two passive, surge-protected RJ45 connections provide maximum equipment compatibility.

Application Example

To guard against costly service calls, and to help your subscriber installations meet code requirements, install two Ubiquiti Ethernet Surge Protectors: one near the CPE, and the other at the entry point to the building. Damaging ESD attacks and surges will be absorbed by the Ubiquiti Ethernet Surge Protector and safely discharged into the ground.